Application Method
Typical Packaging
Search
ArmorLine
Sprayed On Coatings
ArmorFlooring
Rolled or Floor Coatings
ArmorCoat
Top Coat Products
ArmorFloor TopCoat
ArmorPrime
Primer Products
ArmorFoam
Polyurethane Spray Foam
ArmorFloor TopCoat
ArmorFloor is an aliphatic polyaspartic, environmentally friendly surface topcoat for waterproofing membrane systems. It is quick curing and specifically formulated to be installed in thin film applications. ArmorFloor is designed for use in Southern California and is in compliance with SCAQMD air quality standards.
More Details
Mix Ratio by Volume: 1A:1B
Dry Film Thickness per Coat: 14 ± 2 mils; 356 ± 50 microns
Hardness, ASTM D-2240: 65 ± 5 Shore D
Tensile Strength, ASTM D-412: 3500 ± 300 psi; 24.1 ± 2.1 MPa
Ultimate Elongation, ASTM D-412:
Surface Preparation: All surfaces must be free of oil, grease, dirt, and other contaminants.
Application: ArmorFloor can be applied by phenolic resin core roller, high pressure spray, or through a cup gun under low pressure. It should be applied at a minimum film thickness of 5 mils. It should be noted that the heavier the application, the longer the curing process takes.
Apply ArmorFloor evenly over the entire deck. For best results, use an airless sprayer. A phenolic resin core roller may be used, but extra care should be taken not to cause air bubbles.
